Pre-launch preview: not indexed by search engines. Text marked PLACEHOLDER is not final.

Nameplate vs duty cycle vs rated label vs household average: which appliance energy estimate should you use?

Use your model’s rated annual kWh (EnergyGuide or ENERGY STAR) when you know it: it is measured under a standard DOE test. Without it, the household survey average (EIA RECS 2020) is the most realistic typical figure. Nameplate watts are the maximum draw (DOE), so watts × hours is an upper bound except for appliances that draw full power whenever they are on.

Playground: every method on your numbers

Inputs

Best answer

Annual cost$111.36/yr

$111.36/yr$111.36/yr
Low $111.36/yr · likely $111.36/yr · high $111.36/yr

No input here carries a documented range, so no range is shown.

Annual energy
617.3 kWh/yr

Formula Showdown

MethodResultWhen it is right
Nameplate watts × hoursneeds wattsAppliances that draw close to their rated power the whole time they are on (kettle, toaster, hair dryer, bulbs, a heater without a thermostat).
Bias: The nameplate wattage is the maximum power drawn (DOE), so this overestimates appliances that cycle or vary their power (refrigerators, thermostat-controlled heaters and air conditioners).
Watts × duty cycleneeds wattsAppliances that switch on and off to hold a temperature, when you know (or DOE gives) the share of time they actually run. DOE: a refrigerator runs at full power about one third of the time it is plugged in.
Bias: The real duty cycle depends on room temperature, settings and use; DOE’s one-third is a rule of thumb for refrigerators only.
Rated annual kWh (EnergyGuide / ENERGY STAR)needs ratedAnnualKwhWhenever the appliance has a rated annual energy figure (EnergyGuide label or ENERGY STAR listing), especially for refrigerators, freezers and cycle-based appliances.
Bias: The rating is measured under standard test conditions and typical use; your kitchen temperature, settings and usage can differ. Use the usage factor to scale it.

Why this one: Without your model's rating, the measured average for US households is the most realistic typical figure; nameplate watts are only the maximum draw.

Solve for any input

Show the work
  1. Energy per year: Average annual use among US households that have this appliance (RECS 2020)
    E_yr = 617.3 kWh/yr = 617.3 kWh/yr[1]
  2. Annual cost: Annual energy × price per kWh
    C_yr = 617.3 kWh/yr × $0.18/kWh = $111.36/yr[?] Load profile for refrigerator: continuous cycling (DOE test procedure assumes the compressor runs 50% of the time; U.S. Department of Energy).

Sources & data version

  1. U.S. Energy Information Administration (n.d.). 2020 Residential Energy Consumption Survey (RECS): public-use microdata (v7), codebook and end-use model. eia.gov. Verified 2026-10-02.
  • Household survey average (RECS): Residential Energy Consumption Survey RECS 2020 microdata + tables (EIA), 2020 (version 2020-v7+24276158, fetched 2026-10-02)
  • Electricity price: EIA-861M monthly sales and revenue by state: residential average price (Monthly-States sheet), 2025-09 to 2026-08 (version 2026-08+ea3ef7ff, fetched 2026-11-20)
  • Appliance type: your input

Changelog · Methodology

Use this result in

Embed this calculator

Copy this code. The visible credit link must stay.

<iframe src="https://thebestcalculator.com/embed/cost-to-run/" title="Appliance running cost" width="100%" height="720" loading="lazy"></iframe>
<p><a href="https://thebestcalculator.com/">Calculator by The Best Calculator</a></p>

Where the methods disagree (real data)

For each appliance, the average use in US homes that have one (RECS 2020) against the rated energy of a typical new ENERGY STAR certified model. Washers and dishwashers are left out: their ratings include water heating, the survey figure does not.

Refrigerator (firsSecond refrigeratoFreezerClothes dryer (eleTelevision (first)Dehumidifier
Blue: household average (RECS 2020). Grey: typical certified model (ENERGY STAR median rating).
ApplianceHousehold averageTypical certified modelDifference
Refrigerator (first)617 kWh500 kWh+23%
Second refrigerator494 kWh500 kWh−1%
Freezer570 kWh438 kWh+30%
Clothes dryer (electric)680 kWh608 kWh+12%
Television (first)210 kWh186 kWh+13%
Dehumidifier999 kWh301 kWh+232%

The household average covers every age of appliance in real homes; the rating is a standard test of a new model. A large gap means a new efficient model, or a different usage pattern, changes the answer a lot.

The four methods

Nameplate watts × hours

E_yr = W × h × D ÷ 1000

Right when: Appliances that draw close to their rated power the whole time they are on (kettle, toaster, hair dryer, bulbs, a heater without a thermostat).

Known bias: The nameplate wattage is the maximum power drawn (DOE), so this overestimates appliances that cycle or vary their power (refrigerators, thermostat-controlled heaters and air conditioners).

Source: U.S. Department of Energy, Energy Saver (n.d.)U.S. Energy Information Administration (n.d.)

Watts × duty cycle

E_yr = W × d × h × D ÷ 1000

Right when: Appliances that switch on and off to hold a temperature, when you know (or DOE gives) the share of time they actually run. DOE: a refrigerator runs at full power about one third of the time it is plugged in.

Known bias: The real duty cycle depends on room temperature, settings and use; DOE’s one-third is a rule of thumb for refrigerators only.

Source: U.S. Department of Energy, Energy Saver (n.d.)

Rated annual kWh (EnergyGuide / ENERGY STAR)

E_yr = R × u

Right when: Whenever the appliance has a rated annual energy figure (EnergyGuide label or ENERGY STAR listing), especially for refrigerators, freezers and cycle-based appliances.

Known bias: The rating is measured under standard test conditions and typical use; your kitchen temperature, settings and usage can differ. Use the usage factor to scale it.

Source: U.S. Environmental Protection Agency, ENERGY STAR (n.d.)U.S. Department of Energy, Energy Saver (n.d.)

Household survey average (EIA RECS 2020)

E_yr = S (household survey average)

Right when: When you do not know your model’s rating: what US households that have this appliance use on average (typical use, typical age of appliance).

Known bias: An average over all households and appliance ages; your use, climate and model can differ a lot. Older appliances in homes often use more than a new rated model.

Source: U.S. Energy Information Administration (n.d.)

Recommendation rules (the same ones the calculator uses)

  1. A rated annual kWh exists → use it (measured under a standard DOE test procedure).
  2. The appliance draws full power whenever it is on and you know its watts and hours → nameplate watts × hours.
  3. Otherwise, for typical use → the household survey average (RECS 2020).
  4. Cycling appliances with a known duty cycle → watts × duty cycle.
  5. Only nameplate data → treat watts × hours as an upper bound.

Why they differ

Limits

US data only for the household averages and certified-model ratings. Standby power is not counted unless the rating includes it. Figures are estimates, not a measurement of your appliance: a plug-in energy meter measures it directly.

Data: EIA RECS 2020 (microdata v7); ENERGY STAR certified products (snapshot 2026-11-20). Engine method versions: [email protected]. By The Best Calculator (review pending). Changelog.

Open the appliance running cost calculator